RAM Mounts Form-Fit Holder (Key-Locking) for Zebra ET60/65

RAM Mounts Form-Fit Holder (Key-Locking) for Zebra ET60/65

When a Zebra ET60 or ET65 tablet is mounted in a vehicle or warehouse, it needs to stay put — through bumps, busy shifts, and everything in between. This RAM Mounts Form-Fit Holder with key-locking secures the tablet firmly in the cradle. It locks with a key, so the device stays where you put it and doesn't walk off between shifts.

Fitting the tablet takes seconds. Place the bottom edge into the cradle and press until you hear it click into position. That's it — the device is locked and ready.

Charges while docked

The holder connects via a 5.5 mm DC connection, so the tablet charges automatically whenever it's in the cradle. No separate charging cables to remember, no dead battery at the start of a shift. The device is ready to go when your staff pick it up.

All ports and buttons stay accessible

Cut-outs are built into the holder at every button and port position, so your team can use connections and controls without removing the tablet. Work keeps moving even when the device is docked.

The 2-in-1 latch — tablet locked, keyboard still free

The 2-in-1 latch does two jobs at once: it locks the tablet securely in place while still allowing a Zebra keyboard to be opened and closed independently. You don't need to undock the device just to switch between keyboard and touchscreen. This matters in practice — less handling, fewer interruptions.

Optional add-ons for tougher environments

If your site runs cold, the RAM Temp-Right thermal regulation module can be added to the holder. The RAM Vent-Temp uses the vehicle's own ventilation to direct warm or cool air toward the tablet. For sites where NFC scanning distance is a constraint — such as when the tablet stays docked during card reads — an NFC repeater add-on module extends the device's internal NFC reader range.

Compatibility

• ·Fits Zebra ET60 and ET65 tablets
• ·Works with or without the Zebra keyboard
• ·36-month warranty

Get in touch with Vaivatta if you want to confirm compatibility with your current setup or need a hand with installation.