RAM Mounts Form-Fit Holder for Zebra TC53/58

RAM Mounts Form-Fit Holder — Zebra TC53 and TC58

If your team uses a Zebra TC53 or TC58 day in and day out — in a stockroom, on the shop floor, or in a workshop — this RAM Mounts holder gives the device a fixed, reliable home between tasks. It stays put, charges while it sits there, and gets out of the way the moment you need the device in hand.

Picks up and puts down without fumbling

To dock the device, pull the top of the holder upward, drop the TC53 or TC58 in, and let go. The spring-loaded form-fit cradle locks it in place firmly. Taking it out is the same motion in reverse — no twisting, no wrestling with clips. Over a full shift, that adds up.

Charges while the device waits

The holder charges your Zebra through an integrated 5.5 mm DC connector. The included cable runs approximately 125 cm, which gives you enough reach to position the holder where it actually makes sense rather than where the cable forces you. The device charges whether it's actively being used at the mount or simply waiting for the next job.

Works with the Zebra handstrap already attached

The holder is compatible with Zebra's own handstrap, so your team doesn't need to remove it before docking. When the device moves from the mount to someone's hand and back again, nothing slows that transition down.

Ready for a diamond ball base

The back of the holder is prepared for RAM Mounts' diamond ball base, which lets you fix it to a forklift, shelving rig, vehicle cab, or anywhere else a ball-mount post fits. The diamond ball base is not included — you choose the right base for your specific installation point separately.

What's in the box

The package contains the RAM-HOL-ZE17-2U holder and the approximately 125 cm charging cable. The Zebra TC53 or TC58 handset, the diamond ball base, and any other mounting hardware are not included. Country of origin: China.

This holder suits any business where a Zebra TC53 or TC58 is in constant circulation and needs a dedicated spot that keeps it charged and ready — without adding a step to the workflow.