RAM Mounts Form-Fit Holder (Latch) for Zebra L10

RAM Mounts Form-Fit Holder (Latch) for the Zebra XSLATE L10

This holder is built specifically for the Zebra XSLATE L10 tablet. Once the device is seated, you can stop worrying about it shifting or falling — whether you're running a stockroom, a shop floor, or a workshop.

Charges while docked

The holder connects via a 5.5 mm DC port, so your Zebra L10 charges automatically whenever it's in the cradle. No separate cable to plug in at the end of the day — the tablet is ready to go the next morning.

Every port and button stays within reach

Precision cut-outs align with all key buttons, ports, and connectors. You can continue using the device normally — barcode scanner, side connectors, and controls — without having to lift it out of the cradle. The rear cut-out keeps the tablet's scanning function fully operational while mounted.

Accessories stored in the same place

The interior of the cradle has room for tablet accessories: a hand strap, a spare PowerPack battery, or a separate scanner. Everything stays together, so your staff aren't hunting for kit at the start of a shift.

One holder, multiple mounting options

The back of the holder is prepared for either a VESA 75×75 mm plate or a round ball base (neither included). That means the same holder works on a wall arm, a desk stand, or a vehicle mount — no modifications to the holder itself required.

Secure snap-in, quick release

Slide the bottom of the tablet into the cradle and press until it clicks. The latch locks the device in place, so it won't work loose in a busy or mobile environment. Releasing it is just as fast.

Built for daily use

If your Zebra XSLATE L10 is in active use every day, this holder keeps it charged, accessible, and organised without adding steps to your workflow.

• ·Warranty: 36 months
• ·Country of origin: CN