RAM Mounts Form-Fit Holder (Latch) for Honeywell RT10

RAM Mounts Form-Fit Holder (Latch) — Honeywell RT10

Built specifically for the Honeywell RT10 rugged tablet, this RAM Mounts Form-Fit holder keeps the device firmly in place throughout the working day — whether that's on a forklift, a warehouse shelf, or a retail counter.

Charges while docked, ports stay open

The holder draws power through a 5.5 mm DC connection and charges the RT10 at the same time. A built-in dual USB Type-A cable lets you connect peripherals directly from the cradle, so there's no need for extra adapters cluttering the workstation. Cut-outs around the tablet's buttons and ports mean you can send a print job, plug in a cable, or press any button without lifting the device out of the holder first.

Clicks in, stays put

To dock the tablet, lower the bottom edge into the cradle and press gently until the latch clicks into position. That's it. The latch holds the device securely even in high-vibration environments — vehicles, machinery, busy stockrooms. When you need the tablet in hand, releasing it is just as straightforward.

Scanning keeps working in the dock

A cut-out at the back of the holder leaves the RT10's scanning function fully accessible while docked. In a warehouse or shop floor where barcodes get scanned constantly, this means the tablet stays in the holder between scans rather than being lifted in and out every few minutes. Less handling, fewer fumbles.

Accessories stay close

The holder can accommodate tablet accessories — a hand strap or an extended battery pack, for example — keeping everything in one place. No time lost hunting for the strap you put down somewhere on the shelf.

Fits your existing setup

The back of the holder is prepared for a VESA 75×75 mm mounting pattern or a RAM Mounts round ball base (neither is included). That covers most vehicle mounts, wall brackets, and floor stands, so you can install the holder in the position that actually suits your workflow rather than working around the hardware.

Built to last

RAM Mounts designs its mounting systems for demanding daily use. Country of origin: China. Warranty: 36 months.