RAM Mounts Form-Fit Holder for Honeywell CT50, CT60 & CT60 XP

RAM Mounts Form-Fit Holder for Honeywell CT50, CT60 & CT60 XP

If your team docks and undocks a Honeywell CT50, CT60 or CT60 XP multiple times a day — at a shop counter, in a stockroom, or on the workshop floor — the mount needs to keep up. This RAM Mounts Form-Fit holder is built for exactly that: fast, repeatable docking without fiddling with latches or cables.

In and out in one move

Pull the top of the cradle upward, drop the device in, and let go. The spring-loaded mechanism locks it firmly in place. To remove it, the same single motion releases the device cleanly — no extra buttons, no tools. When your staff are busy and hands are full, that matters.

Charges while it sits

The holder connects via USB-A 2.0, so the Honeywell device tops up its battery every time it goes back in the cradle. The cable runs 125 cm, which reaches most counter and wall mounting positions without needing an extension lead. At the end of a shift, putting the device away is all it takes — no separate charger to hunt for.

Stylus stays where it should

The holder includes a dedicated stylus pen slot, so the pen is always within reach rather than lost on a counter or stuffed in someone's pocket.

Fits your existing RAM mount setup

The back of the holder is prepared for a RAM diamond ball base, so it slots straight into any existing RAM Mounts installation. The diamond ball base is not included — only the RAM-HOL-HON7U holder ships in the box.

What's in the box

• ·Included: RAM-HOL-HON7U holder with 125 cm USB-A 2.0 cable
• ·Not included: Honeywell device, diamond ball base
• ·Warranty: 36 months
• ·Country of origin: China

This holder suits any SMB running Honeywell CT50, CT60 or CT60 XP handhelds as daily tools — retail, warehousing, or repair workshops where the device needs to be charged, accessible, and quick to grab.