RAM Mounts GDS Holder for Zebra EC50/55

RAM Mounts GDS Holder for Zebra EC50/55

This RAM Mounts GDS holder is built specifically for the Zebra EC50 and EC55, used with the IntelliSkin protective sleeve. It's designed for daily use in shops, stockrooms, and workshops — anywhere you need the device within reach and charged throughout the working day.

Charges automatically in the dock

The holder connects via USB-C, so your Zebra EC50/55 starts charging the moment you place it in the cradle. No separate cable to plug in — set it down and it charges.

Spring-loaded design keeps the device secure

Inserting the device takes one motion: pull the upper part of the cradle upward, place the device in, and the spring-loaded mechanism locks it firmly in position. It stays put even in busier, moving environments — no accidental drops.

Top scanner and buttons stay fully accessible

With the device seated in the holder, the Zebra EC50/55's top scanner and side buttons remain completely unobstructed. You can scan barcodes and operate the device normally without removing it from the cradle.

Room for standard and extended battery packs

The back of the holder accommodates both the standard and extended battery pack, so you're not forced to switch battery sizes when mounting. The Zebra hand strap fits too, meaning the device's existing setup carries over.

Ready for diamond ball base mounting

The rear of the holder is prepared for a diamond ball base (not included), which means you can integrate it into the wider RAM Mounts system — fixed arms, adjustable mounts, vehicle brackets — whatever your setup calls for.

Compatibility

This holder works exclusively with the IntelliSkin protective sleeve. Before ordering, confirm that your Zebra EC50 or EC55 is fitted with the correct IntelliSkin cover.

Country of origin: China. Warranty: 36 months.